Fabricating the Single-Lift Topsides

The Perdido team faced a tough decision. A conventional topsides design required a series of modules that would have to be fabricated onshore, then lifted onto the spar and integrated offshore, but what if the team could constrain the design enough that it could be built and lifted in one piece?

Send this story to:

Enter the email address of the recipient.
Separate multiple addresses with commas.

Add your own personal message:

Enter your email address:

Note: Your email address is used only to let the recipient know who sent the story, and in case of transmission error. Both your address and the recipient's address will not be used for any other purpose.